Cart 0

I want to install UniCam Connectors on a fan-out cable; is there anything special I should know?

The most critical step in terminating UniCam Connectors on fan-out cable is to leave 4 mm of the 250 µm coating extending beyond the 900 µm fan-out tubing. The 4 mm will allow the fiber to piston in the fan-out tubing and still maintain the fiber mating in the splice area of the UniCam Connector. Refer to Sections 3.5 (MT-RJ), 4.5 (LC) and 5.6 (SC, ST Compatible, FC) of SRP-006-150 for further instructions.

Share this post



Sold Out