sales@foscoconnect.com
(510) 319-9878
Silicon Valley, CA, USA
Overview
The 3M ST Hot Melt Connector is a field-installable fiber optic connector designed for efficient, reliable terminations in singlemode applications. Engineered to simplify the termination process, this connector utilizes advanced adhesive technology that eliminates the need for messy liquid epoxies, significantly reducing preparation time for installers.
These connectors are designed to be terminated in two minutes or less, allowing for rapid deployment in the field. A key advantage of this design is its re-heatability, which enables technicians to adjust or reposition the fiber if necessary during the installation process. This connector is ideal for high-speed fiber network environments where precision and speed of installation are critical requirements.
Key Features
-
Advanced Adhesive Technology
Uses pre-loaded adhesive to eliminate the application of liquid epoxy, saving time and improving consistency. -
Rapid Termination
Capable of being terminated in two minutes or less to increase field installation productivity. -
Re-heatable Design
Allows for fiber repositioning if needed, reducing waste and ensuring proper alignment. -
Low Insertion Loss
Features a typical insertion loss of 0.2dB to maintain high signal integrity. -
ST Style Compatibility
Industry-standard ST form factor ensures compatibility with a wide range of existing hardware. -
Singlemode Optimized
Precision-engineered for 126µm cladding applications, supporting high-performance network requirements.
Applications
- Local Area Network (LAN) backbone installations
- Fiber-to-the-desk (FTTD) connectivity
- Field restoration and emergency fiber repairs
- General premise cabling
Technical Specifications
| Specification | Value |
|---|---|
| Manufacturer | 3M |
| Connector Style | ST |
| Fiber Mode | Singlemode |
| Cladding Diameter | 126µm |
| Termination Time | 2 minutes or less |
| Typical Insertion Loss | 0.2dB |
| Adhesive Type | Hot Melt (Pre-loaded) |
Frequently Asked Questions
Can these connectors be reused if the termination fails?
Yes, the 3M Hot Melt connectors are re-heatable, allowing you to reheat the connector and reposition the fiber if the initial termination is not satisfactory.
Do I need to buy separate epoxy?
No, these connectors utilize an advanced internal adhesive that is activated by heat, eliminating the need for separate epoxies or curing agents.
How long does it take to terminate one connector?
The system is designed to allow technicians to complete a termination in two minutes or less.
Is this connector compatible with multimode fiber?
This specific part is designed for singlemode 126µm applications; please ensure your fiber type matches the connector specifications.
Is an oven required for installation?
Yes, an appropriate 3M Hot Melt connector oven is typically required to activate the pre-loaded adhesive correctly.
Downloads