SpecSeal Ready Firestop Grommet contains a 10-pack of two-piece split cable grommet for cable penetration up to 0.27 in. (7 mm) O.D.

For a single cable or small multi-cable bundles penetrating through one- and two-hour fire-rated gypsum board walls, eliminating sleeves, sealant and putty.

Single or small multi-cable penetrations can be time consuming, expensive and messy.

Ready Firestop Grommets make membrane and through-penetrations through rated gypsum board walls a snap.

Just drill a hole, run your cable(s), snap the grommet around the cable(s) and press it into the wall.

Use a single grommet for single-sided (membrane) penetrations or drill a hole through both sides of the wall and install grommets back-to-back for through-penetrations.

The Ready Firestop Grommet is available in two sizes.

RFG1 for a cable or bundle of cables up to 0.27 in (7 mm) O.D or RFG2 for up to 0.53 in (14 mm) O.D.

The grommet is molded from a premium grade plenum-rated polymer.

A soft foam inner core conforms to the cable(s) to form a tight seal.

The cable(s) is smoke-sealed and firestopped in just minutes with no sleeve and no sealant or putty required!

Features:

• Quick to install - two-piece grommet snaps together for an easy installation.
• Economical - eliminates sleeves and the need for putty or sealant.
• Split design - can be used with previously installed cables.
• Made with Ultem premium, plenum-grade material - exceptional flame and heat resistance.

Product Sheet:

• Spec Sheet