Loctite 680 High Strength/High Viscosity Anaerobic Adhesive ( Ground Shipment Only)
This item comes in a 10ml bottle.
LOCTITE Product 680 is a high strength, single component anaerobic retaining adhesive for cylindrical joints. The product cures when confined in the absence of air between close fitting metal surfaces.
This product is used on specially designed Anaerobic connectors. Please refer to our connectors department for more information about these connectors.
680 can be used with Loctite 7649 Primer N to increase cure speed.
Please Note: Ground Shipment Only
Direction of Use:
- Inject Loctite 680 into the connector with a syringe needle, dip or spray the fiber with Loctite 7649 (PN:7649) and connectorize as usual.
Specifications:
- Chemical Type: Methacrylate Ester
- Appearance: Green Liquid
- Specific Gravity @ 2°C: 1.1
- Viscosity @ 2°C, mPa.s (cP) Brookfield RVT Spindle 3 @ 20 rpm: 1250
- Flash Point (TCC),°C: >93
Storage:
Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between ° to 2°C (4° to 8°F) unless otherwise labeled. To prevent contamination of unused product, do not return any material to its original container.
Product Detail
Must be shipped ground. This is a two-part Fiber Optic Anaerobic Adhesive system that self cures in minutes with no heat required. To use, you inject the retaining compound into the connector with a syringe needle. Next, dip or spray the optical fiber with primer and connectorize as usual. You will find that this Fiber Optic Anaerobic Adhesive sets up in seconds, and is fully cured in minutes. This adhesive is available for domestic ground shipment only! See Anaerobic Fiber Optic Connectors available from FOSCO.
Note: FOSCO does not recommend the use of anaerobic adhesive unless this type of adhesive is specified by the fiber optic connector manufacturer. FOSCO is not liable for product or labor loss, and will not accept returns on this item. Shipping restrictions and fees may apply.
Product Sheet: