Menu
Cart 0
POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system
Move your mouse over image or click to enlarge
POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system

POE-01-DIN - Full 8 pin Cat6 RJ45 Ethernet surge protector with PoE support and DIN rail mount system

CTC Union Part No.: POE-01-DIN

  • $ 37.00 or


POE-01-DIN is an in-line RJ45 Ethernet Cat6 cable surge protector that can be attached to a DIN rail system. It installs simply on a Cat5, Cat 5e or Cat6 4 twisted pair cable. Device is using special diodes and gas discharge modules for effective lightning protection. It protects any RJ45 Ethernet based device like switches, DSL modems, routers, computers, etc. while allowing PoE 802.3af/at powered cables to pass through the PoE power to remote cameras or WiFi/VoIP equipment. The PoE feature allows protection of the expensive CO equipment against lightning and other industrial power surges. When installed on a DIN rail, 17 such protectors can be put side by side in a 19" wide DIN rail mounted on a rack (See second photo). For 35mm DIN rails, please check the related items for mounting protectors on a rack including the DINRAIL-19.

Earthing bars for 5 and 10 units are sold separately. These bars connect the grounding of all DIN rail installed protectors and then provide a single point for grounding to the electrical ground. Such connection is crucial for the efficiency of the protectors and the copper bars are best conductors for grounding. For copper earthing bars DIN-GBAR-5 and DIN-GBAR-10, please also check the related items.

The 8 pin surge protector is also good for RJ48c 100ohm T1 interfaces, providing effective surge protection on all 8 pin connectors from the T1 copper interface.

Note: This special surge protector version does SUPPORT the IEEE 802.3af PoE standard (Power over Ethernet). You can use such protector on PoE active cabling. The compatibility is assured with the IEEE 802.3af/at standard by supporting a much higher clamping voltage of 57V.

Features of POE-01-DIN RJ45 Ethernet and T1 surge protector
Fast energy absorption on over-voltage
Low resistance and minimal capacitance - minimal influence on data link
Easy in-line installation: two RJ45 female connectors

Technical specifications
Discharge current max.: 5KA
Discharge current nominal: 0.5KA
Max. voltage: 57V PoE (all pins)
Response time: line-line<1ns, line-ground<100ns
Insertion loss: <2.0dB (250MHz)
Capacity: <= 165pF (line-to-line)
Dimensions: 106.2mm x 37.6mm x 25.6mm
Weight: 75g

Additional information on POE-01-DIN: PDF Datasheet

Sale

Unavailable

Sold Out