Archived

Buy Fiber Optic Cable Management Products Here There are two basic types of bends in fiber—microbends and macrobends. As the names indicate, microbends are very small bends or deformities in the fiber, while macrobends are larger bends (see the figure below). The fiber’s radius around bends impacts the fiber network’s long-term reliability and performance. Simply put, fibers bent beyond the specified minimum bend diameters can break, causing service failures and increasing network operations costs. Cable manufacturers, Internet and telecommunications service providers, and others specify a minimum bend radius for fibers and fiber cables. The minimum bend radius will vary

Buy Optical Fiber Here Three methods are used today to fabricate moderate-to-low loss waveguide fibers: modified chemical vapor deposition (MCVD), outside vapor deposition(OVD), and vapor axial deposition (VAD). Modified Chemical Vapor Deposition (MCVD) In MCVD a hollow glass tube, approximately 3 feet long and 1 inch in diameter (1 m long by 2.5 cm diameter), is placed in a horizontal or vertical lathe and spun rapidly. A computer-controlled mixture of gases is passed through the inside of the tube. On the outside of the tube, a heat source (oxygen/hydrogen torch) passes up and down as illustrated in the following

Buy Fiber Optic Connectors Here The most basic design of demountable connector comprises a ferrule of hole diameter 128–129 μm into which the fiber is bonded using an appropriate adhesive as in the figure below. In this most fundamental form the ferrules can be rotated through 360° within an alignment tube or adaptor. This rotation allows any eccentricity to be fully explored as is discussed below. In addition a gap of perhaps 5–10 μm is incorporated between the ferrule faces. This gap is intended to prevent damage to the fiber ends but has the disadvantage that it incurs both Fresnel

Buy Fiber Optic Couplers Here What is a fiber optic coupler? A coupler is an optical device that combines or splits signals travelling on optical fibers. A port is an input or output point for light; a coupler is a multiport device. A coupler is passive and bidirectional. Because the coupler is not a perfect device, excess losses can occur. These losses within fibers are internal to the coupler and occur from scattering, absorption, reflections, misalignments, and poor isolation. Excess loss does not include losses from connectors attaching fibers to the ports. Further, since most couplers contain an optical fiber

Buy Fiber Optic Light Source Here Optical signals begin at the source with lasers or LEDs transmitting light at the exact wavelength at which the fiber will carry it most efficiently. The source must be switched on and off rapidly and accurately enough to properly transmit the signals. Lasers are more powerful and operate at faster speeds than LEDs, and they can also transmit light farther with fewer errors. LEDs, on the other hand, are less expensive, more reliable, and easier to use than lasers. Lasers are primarily used in long-distance, high-speed transmission systems, but LEDs are fast enough and